City guide

Plumbers in Huntsville, AL

A local guide to plumbing in Huntsville, Alabama (Madison County): numbers on housing, weather and utilities, plus what to check before you hire a plumber.

Population
About 230,402 residents (U.S. Census Bureau 2024 estimate)
County
Madison County, Alabama
Homes
Median year built 1985; 44% of homes built before 1980, 33% since 2000
Housing mix
63% detached single-family houses; 58% of homes owner-occupied
Home heating fuel
Electricity 75%, utility gas 23%
Winter
Average winter daily low 35°F; about 56 nights a year at or below 32°F
Summer
Average summer daily high 91°F; about 62 days a year at 90°F or hotter
Precipitation
About 59.2 in of precipitation a year; about 2.4 in of snowfall
Flash floods 2015-2024
81 flash flood reports in Madison County
Electric utility
City of Huntsville serves most local ZIP codes; average residential rate about 11.5 cents per kWh (2023)
ZIP codes
35741, 35756, 35763, 35801, 35802, 35803, 35805, 35806, 35810, 35811, 35816, 35824, 35896

Plumbing in Huntsville: what the local numbers say

With a median build year around 1985, a typical home in Huntsville was plumbed in the 1980s or 1990s. Some homes from that period used polybutylene supply pipe, which was installed until about the mid-1990s and has been linked to leaks at its fittings. Others have copper, early CPVC or PEX. A plumber can usually tell which you have by looking at the pipes near the water heater.

Occasional freezing nights are enough to cause trouble in Huntsville, which sees about 56 of them and roughly 2,830 heating degree days. Because freezes are not constant, many homes lack the protection found in colder regions. Learn where your main shutoff is, insulate exposed pipes and know how to drain outdoor lines. If a pipe does split, shutting off the water quickly limits the damage.

In Huntsville, where roughly 75% of homes use electric heat, electric water heaters and heat pump water heaters are common choices. Heat pump models need clearance, a condensate drain and enough surrounding air, while standard tanks need a dedicated circuit. Because power and plumbing meet in this appliance, ask which trade will handle each part of an installation.

Madison County logged 81 flash flood reports from 2015 to 2024, so water intrusion is a realistic concern in Huntsville. Know where your main water shutoff is, keep the water heater and electrical panel above likely flood levels when possible, and ask a plumber about a backflow or backwater valve. After a flood, have supply lines and drains checked before the system is put back in use.

Huntsville gets about 59.2 in of precipitation a year, and constant moisture is hard on plumbing and the structures around it. Sump pumps run often, crawl spaces collect water and sewer lines can fill with groundwater through cracked joints. A battery backup for the sump pump, a working check valve and a plumber's camera inspection of the main line are sensible steps for homes in wet areas.

Permits, water and local rules in Huntsville

Trade permits for plumbing and gas

The City of Huntsville says most trades for electrical, plumbing, mechanical and gas, as well as some roofing and siding permits, can be obtained online. Projects in a FEMA Special Flood Hazard Area must be submitted in person, and most building and standalone trade permits there need a Flood Development Permit before other permits are approved. The Inspection Office can be reached at 256-427-5331 for questions about a specific project. Source: City of Huntsville, Building License and Permits.

Business licenses and owner-pulled permits

The city states that anyone conducting business within Huntsville city limits must obtain a business license from the Finance Department before starting work, and contractors who use subcontractors must file a Sub-contractors Schedule C form. A property owner may purchase a residential building permit if they plan to live in the house for at least one year after final completion and provide a copy of the recorded deed. The page adds that acting as your own contractor is not recommended. Source: City of Huntsville, Building License and Permits.

Water sources and hardness

Huntsville Utilities says its surface water is pumped from the Tennessee River and is typically soft, averaging about 65 to 75 mg/L, while groundwater from limestone aquifers ranges from 160 to 170 mg/L. It says water in that harder range tends to precipitate out calcium when heated, so it adds an ortho-polyphosphate and notes that a lower water heater temperature setting can reduce calcium precipitation. Hardness depends on location; the utility's Water Quality Lab is at (256) 650-6374. Source: Huntsville Utilities, Water.

Neighborhoods and districts in Huntsville include Twickenham Historic District, Old Town Historic District, Lowe Mill Village, Dallas Mill Village, Lincoln Mill Village, Anderson Hills and MidCity.

Common plumbing jobs in Huntsville

Before you hire anyone in Huntsville, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Alabama plumbing guide explains where to start.

Common questions in Huntsville

Do I need to worry about frozen pipes in Huntsville?

Occasional freezes happen, and homes built for milder weather often have exposed lines. Huntsville sees about 56 freezing nights in a typical year. Before a forecast freeze, cover spigots, disconnect hoses and insulate pipes in attics, garages and exterior walls. Know the location of your main shutoff so you can stop water quickly if a pipe splits.

What plumbing helps protect a home from sewer backup during floods in Huntsville?

A backwater valve on the sewer line, a sump pump with battery backup and a known main shutoff are common measures. Madison County had 81 flash flood reports in 2015 to 2024. Whether a valve suits your home depends on your drain layout and local code, so ask a plumber and check permit rules.

Can I get a plumbing permit online in Huntsville?

The city says most trade permits, including plumbing and gas, can be obtained online. Projects in a FEMA Special Flood Hazard Area must be submitted in person. For project-specific questions, the Inspection Office can be reached at 256-427-5331.

Is Huntsville water hard, and does it affect water heaters?

Huntsville Utilities says surface water averages about 65 to 75 mg/L, while groundwater runs 160 to 170 mg/L. At the higher level, calcium tends to precipitate out when heated, and the utility says lowering the water heater temperature setting can reduce it. Hardness depends on your location.

Other Alabama cities

Call (844) 609-3677