City guide

Plumbers in Long Beach, CA

A local guide to plumbing in Long Beach, California (Los Angeles County): numbers on housing, weather and utilities, plus what to check before you hire a plumber.

Population
About 450,901 residents (U.S. Census Bureau 2024 estimate)
County
Los Angeles County, California
Homes
Median year built 1959; 79% of homes built before 1980, 6% since 2000
Housing mix
40% detached single-family houses; 41% of homes owner-occupied
Home heating fuel
Utility gas 61%, electricity 30%
Winter
Average winter daily low 47°F; about 0 nights a year at or below 32°F
Summer
Average summer daily high 80°F; about 23 days a year at 90°F or hotter
Precipitation
About 12 in of precipitation a year
Flash floods 2015-2024
89 flash flood reports in Los Angeles County
Electric utility
Southern California Edison Co. serves most local ZIP codes; average residential rate about 24.1 cents per kWh (2023)
ZIP codes
90802, 90803, 90804, 90805, 90806, 90807, 90808, 90810, 90813, 90814, 90815, 90822, 90831, 90840

Plumbing in Long Beach: what the local numbers say

The median home in Long Beach was built around 1959, and about 52% of the housing stock predates 1960. Homes from that era often still have galvanized steel supply lines that corrode from the inside and lose pressure, along with cast iron or clay drain lines that crack or collect roots. A plumber can scope the main sewer line before you buy or remodel, which can help avoid surprises behind the walls.

Winters in Long Beach are mild, with typical lows near 47°F and few freezing nights. The risk is not constant frozen pipes but rare cold snaps that find homes unprepared: uninsulated lines, exposed pipes near the water heater and outdoor valves. Keep foam covers on hand and know your main shutoff. If a pipe splits, shut off the water first, then call a plumber.

Utility gas serves a large share of Long Beach homes (61% use it for heating), which makes gas tank and tankless water heaters a routine plumbing job here. Tankless gas units often need larger gas lines and specific vent materials, and they may need descaling where water is hard. Ask a plumber to confirm gas line capacity before choosing a model.

Flash flooding is a recurring hazard near Long Beach: Los Angeles County recorded 89 flash flood reports between 2015 and 2024. Floodwater and sewer overload can push sewage back through floor drains and lower fixtures. A backwater valve on the sewer line, a sump pump with battery backup and raised utilities may help, and a plumber can tell you which makes sense for your property.

Long Beach gets about 12 in of precipitation a year, a semi-arid climate where hard water is common and sudden downpours can overwhelm drains. Scale builds up in water heaters and fixtures, while dry soil and heavy rain cycles may shift buried sewer lines. Ask a plumber about flushing your tank, checking cleanouts and keeping downspouts away from the foundation.

Permits, water and local rules in Long Beach

Water heater plumbing permits

Long Beach's plumbing requirements page says a plumbing permit is required for water heating equipment that is installed, altered, repaired or replaced, unless an exemption applies under LBMC 18.04.020(E). One listed exemption is repairing water heaters, excluding vents, without disconnecting them. Permits become invalid if work does not begin within 180 days of issuance. The page also states that all plumbing work must comply with the Uniform Plumbing Code and Long Beach plumbing regulations. Source: City of Long Beach, Mechanical, Electrical and Plumbing Code Requirements.

Seismic strapping and relief valve rules

Long Beach states that a water heater must be anchored or strapped with approved materials to resist horizontal displacement from earthquake motion, with strapping in the upper one-third and lower one-third of its height and the lower strap at least four inches above the controls. All water heaters are included regardless of fuel source, and heaters over 100 gallons or more than 12 inches from a wall require a designed system. Removing or blocking the temperature and pressure relief valve is a code violation. Source: City of Long Beach, Mechanical, Electrical and Plumbing Code Requirements.

Moderately hard to hard water

Long Beach Utilities describes the city's water as moderately hard to hard, explaining that hardness refers to dissolved minerals such as calcium and magnesium. It calls a water softener a personal preference and notes that salt softeners add sodium, which may concern people with certain health conditions. The utility also states that it does not use lead service lines in its distribution system and identifies lead-containing plumbing fixtures in homes as the other possible source of lead. Source: Long Beach Utilities, Your Drinking Water.

Groundwater and imported supply

Long Beach Utilities states that the city has rights to pump about 33,000 acre-feet of groundwater per year, enough to meet about sixty percent of its water needs. Imported water supplies the remaining share, roughly 40 percent, from the Colorado River watershed and the Sacramento-San Joaquin Bay Delta through the Metropolitan Water District of Southern California. Because the mix of sources can change, the utility's annual water quality information is the place to check current figures. Source: Long Beach Utilities, Ground and Imported Water.

Neighborhoods and districts in Long Beach include Bixby Knolls, California Heights, Los Cerritos, North Long Beach, Belmont Heights, Belmont Shore, Naples and Wrigley.

Common plumbing jobs in Long Beach

Before you hire anyone in Long Beach, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The California plumbing guide explains where to start.

Common questions in Long Beach

Do older homes in Long Beach usually need their pipes replaced?

Not always. Homes built before 1960 may still have galvanized steel, cast iron or clay lines, and some have lead service lines. Age alone does not mean replacement; condition does. A plumber can check pressure, inspect drains with a camera and identify pipe material, and your water utility can tell you what it has recorded for the service line.

What should I ask when replacing a gas water heater in Long Beach?

Ask about venting type and condition, combustion air, the gas line and connector, and whether a local permit and inspection are required; your city or county permit office can confirm. About 61% of homes here use gas for heating, so many have gas units. Verify the plumber's license with the state licensing board before work starts.

Does a water heater replacement in Long Beach need a permit?

Long Beach's plumbing requirements say a plumbing permit is required for water heating equipment that is installed, altered, repaired or replaced, unless an exemption applies. One exemption covers repairs to a water heater, excluding vents, without disconnecting it. Permits become invalid if work does not begin within 180 days of issuance.

Do water heaters in Long Beach have to be strapped for earthquakes?

Yes. Long Beach states that all water heaters, regardless of fuel source, must be anchored or strapped to resist earthquake movement, with straps in the upper and lower thirds of the tank and the lower strap at least four inches above the controls. Heaters over 100 gallons or more than 12 inches from a wall need a designed system.

Other California cities

Call (844) 609-3677