City guide

Plumbers in Chicago, IL

A local guide to plumbing in Chicago, Illinois (Cook County): numbers on housing, weather and utilities, plus what to check before you hire a plumber.

Population
About 2,721,308 residents (U.S. Census Bureau 2024 estimate)
County
Cook County, Illinois
Homes
Median year built 1953; 75% of homes built before 1980, 15% since 2000
Housing mix
26% detached single-family houses; 46% of homes owner-occupied
Home heating fuel
Utility gas 78%, electricity 18%, propane 2%
Winter
Average winter daily low 23°F; about 96 nights a year at or below 32°F
Summer
Average summer daily high 79°F; about 13 days a year at 90°F or hotter
Precipitation
About 34.4 in of precipitation a year; about 38.8 in of snowfall
Flash floods 2015-2024
67 flash flood reports in Cook County
Electric utility
Commonwealth Edison Co. serves most local ZIP codes; average residential rate about 10.9 cents per kWh (2023)
ZIP codes
60018, 60608, 60609, 60617, 60619, 60620, 60623, 60628, 60629, 60632, 60633, 60634, 60638, 60643

Plumbing in Chicago: what the local numbers say

With a median build year of 1953 in Chicago, many houses were plumbed before modern materials existed. Older water service lines may be lead or galvanized steel, and your water utility can tell you what material it has recorded for your address. If low pressure, rusty water or slow drains show up, an aging pipe is a common suspect worth having a local plumber inspect.

Chicago gets around 96 nights a year at or below 32°F, with typical winter lows near 23°F. That is enough for pipes in exterior walls, crawl spaces and garages to freeze during cold snaps. Before winter, drain outdoor lines, close foundation vents to crawl spaces and ask a plumber to look at any pipe that runs through unheated space.

Natural gas is the main heating fuel in Chicago, used by roughly 78% of homes, so gas water heaters are common. They tend to need attention to venting, sediment at the bottom of the tank and the flexible gas connector. When replacing one, ask the plumber about venting, whether a permit and inspection are required locally, and what the new unit needs for combustion air.

With 67 flash flood reports in Cook County over 2015 to 2024, homes in Chicago may face storm-driven backups at some point. Floor drains and basement bathrooms are the first places sewage backs up. Ask a plumber about a backwater valve, a check valve on the sump pump and a clear route for discharge water. Photograph the shutoff and cleanout locations now.

With around 34.4 in of precipitation in a typical year, Chicago homes see steady moisture around foundations. Sump pumps, floor drains and downspout connections matter more than in drier regions. Test a sump pump by pouring water into the pit before a heavy storm, and ask a plumber whether your downspouts or footing drains are tied into the sewer, since local rules on that vary.

Permits, water and local rules in Chicago

Water heater permit conditions

The Department of Buildings terms for plumbing permits include a section on repairing or replacing a water heater. It requires installation per the manufacturer's instructions, with a copy on site at inspection, unions on the connections, dielectric fittings between dissimilar metals, and a full port 3/4 in shutoff valve on the cold water branch with no valve on the hot side. A relief valve outlet may not connect directly to the drain. For a fuel-fired heater inside a dwelling, the installer must verify a working carbon monoxide detector is present. Source: City of Chicago, Terms and Conditions for Plumbing Work.

Who may do plumbing work

The City states that a plumbing contractor with a City of Chicago license, and bonded, is required for most plumbing work. The one exception is the owner, occupant or lessee of a detached single-family residence, who may personally install, alter or repair the plumbing of that residence. That work must still follow the Chicago Plumbing Code and be inspected, and the exception does not let an owner hire anyone other than a contractor holding the City plumbing license. The plumbing code edition that applies is the one in effect when the permit application was submitted. Source: City of Chicago, Does my project require a plumbing contractor?.

Lead service line inventory

The Department of Water Management's 2023 Water Quality Report says that a house or two-flat built before 1986 has a high likelihood of a lead water service line. It points owners to the citywide Service Line Inventory at SLI.ChicagoWaterQuality.org and describes several City lead service line replacement programs, including an Equity program for owners of a house or two-flat with household income below 80 percent of the area median. DWM says it notifies residents of eligibility and next steps. Source: Chicago Department of Water Management, 2023 Water Quality Report.

Water service and cross connection permits

The Department of Buildings' Water Plan Desk issues permits for the connection, disconnection and alteration or repair of water services on behalf of the Department of Water Management, and it receives applications for the initial testing of cross connection control devices. Any deviation from a typical installation must be approved by DWM's Bureau of Engineering. The page also says a permit fee waiver exists for owner-initiated voluntary replacement of an existing lead service line, with the amount and limits stated on that page. Source: City of Chicago, Water Service Permits.

Neighborhoods and districts in Chicago include Lincoln Park, Lake View, Logan Square, Hyde Park, Rogers Park, Bridgeport, Uptown, Pilsen, Wicker Park and Austin.

Common plumbing jobs in Chicago

Before you hire anyone in Chicago, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Illinois plumbing guide explains where to start.

Common questions in Chicago

Do older homes in Chicago usually need their pipes replaced?

Not always. Homes built before 1960 may still have galvanized steel, cast iron or clay lines, and some have lead service lines. Age alone does not mean replacement; condition does. A plumber can check pressure, inspect drains with a camera and identify pipe material, and your water utility can tell you what it has recorded for the service line.

What should I ask when replacing a gas water heater in Chicago?

Ask about venting type and condition, combustion air, the gas line and connector, and whether a local permit and inspection are required; your city or county permit office can confirm. About 78% of homes here use gas for heating, so many have gas units. Verify the plumber's license with the state licensing board before work starts.

Can a homeowner in Chicago do their own plumbing work?

The City says the owner, occupant or lessee of a detached single-family residence may personally install, alter or repair the plumbing of that residence without a plumbing contractor license. The work must follow the Chicago Plumbing Code and be inspected, and the exception does not allow hiring anyone other than a contractor holding the City plumbing license.

How can I find out if my Chicago home has a lead service line?

The Department of Water Management says a house or two-flat built before 1986 has a high likelihood of a lead service line. Owners can look up an address in the citywide Service Line Inventory at SLI.ChicagoWaterQuality.org. DWM also describes City replacement programs that residents can ask about.

Other Illinois cities

Call (844) 609-3677