City guide

Plumbers in High Point, NC

What plumbing in High Point, NC depends on: the age of local homes, winter freezes, rainfall and the water utility. Facts below come from official sources. Call to be connected with a local plumber.

Population
About 118,601 residents (U.S. Census Bureau 2024 estimate)
County
Guilford County, North Carolina
Homes
Median year built 1989; 40% of homes built before 1980, 33% since 2000
Housing mix
63% detached single-family houses; 58% of homes owner-occupied
Home heating fuel
Utility gas 48%, electricity 48%, propane 2%
Winter
Average winter daily low 33°F; about 68 nights a year at or below 32°F
Summer
Average summer daily high 88°F; about 45 days a year at 90°F or hotter
Precipitation
About 48.3 in of precipitation a year; about 1.9 in of snowfall
Flash floods 2015-2024
56 flash flood reports in Guilford County
Electric utility
Duke Energy Carolinas, LLC serves most local ZIP codes; average residential rate about 11.9 cents per kWh (2023)
ZIP codes
27260, 27262, 27263, 27265, 27268, 27282

Plumbing in High Point: what the local numbers say

With a median build year around 1989, a typical home in High Point was plumbed in the 1980s or 1990s. Some homes from that period used polybutylene supply pipe, which was installed until about the mid-1990s and has been linked to leaks at its fittings. Others have copper, early CPVC or PEX. A plumber can usually tell which you have by looking at the pipes near the water heater.

High Point has roughly 68 freezing nights a year, which is not many but enough to catch homes off guard. Pipes in attics, garages, exterior walls and outdoor spigots are often left uninsulated where freezes are infrequent. Before a forecast freeze, disconnect hoses, cover spigots and ask a plumber about insulation for any exposed supply lines.

A mix of gas (48%), electric (48%) and delivered fuels heats homes across High Point, so there is no standard water heater setup. Check the tag on your unit for the fuel and capacity, and the serial number, which many manufacturers use to encode age. A local plumber can tell you what a like-for-like replacement would need in your house.

With 56 flash flood reports in Guilford County over 2015 to 2024, homes in High Point may face storm-driven backups at some point. Floor drains and basement bathrooms are the first places sewage backs up. Ask a plumber about a backwater valve, a check valve on the sump pump and a clear route for discharge water. Photograph the shutoff and cleanout locations now.

High Point gets about 48.3 in of precipitation a year, and constant moisture is hard on plumbing and the structures around it. Sump pumps run often, crawl spaces collect water and sewer lines can fill with groundwater through cracked joints. A battery backup for the sump pump, a working check valve and a plumber's camera inspection of the main line are sensible steps for homes in wet areas.

Common plumbing jobs in High Point

Before you hire anyone in High Point, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The North Carolina plumbing guide explains where to start.

Common questions in High Point

Do I need to worry about frozen pipes in High Point?

Occasional freezes happen, and homes built for milder weather often have exposed lines. High Point sees about 68 freezing nights in a typical year. Before a forecast freeze, cover spigots, disconnect hoses and insulate pipes in attics, garages and exterior walls. Know the location of your main shutoff so you can stop water quickly if a pipe splits.

What plumbing helps protect a home from sewer backup during floods in High Point?

A backwater valve on the sewer line, a sump pump with battery backup and a known main shutoff are common measures. Guilford County had 56 flash flood reports in 2015 to 2024. Whether a valve suits your home depends on your drain layout and local code, so ask a plumber and check permit rules.

Other North Carolina cities

Call (844) 609-3677