City guide
Plumbers in Tulsa, OK
Plumbing in Tulsa, Oklahoma: housing age, climate and water facts from official sources, and how to be connected with a local plumber for drain cleaning, leak detection, water heater repair, emergency plumbing, bathroom remodeling and fixture installation.
- Population
- About 415,154 residents (U.S. Census Bureau 2024 estimate)
- County
- Tulsa County, Oklahoma
- Homes
- Median year built 1973; 65% of homes built before 1980, 14% since 2000
- Housing mix
- 62% detached single-family houses; 52% of homes owner-occupied
- Home heating fuel
- Utility gas 58%, electricity 40%
- Winter
- Average winter daily low 30°F; about 72 nights a year at or below 32°F
- Summer
- Average summer daily high 92°F; about 74 days a year at 90°F or hotter
- Precipitation
- About 44.2 in of precipitation a year; about 8.7 in of snowfall
- Flash floods 2015-2024
- 138 flash flood reports in Tulsa County
- Electric utility
- Public Service Co of Oklahoma serves most local ZIP codes; average residential rate about 13.8 cents per kWh (2023)
- ZIP codes
- 74015, 74105, 74106, 74107, 74108, 74112, 74115, 74116, 74127, 74132, 74133, 74134, 74136, 74137
Plumbing in Tulsa: what the local numbers say
The median home in Tulsa was built in 1973, in many cases before the 1986 federal ban on lead solder in drinking water systems. Copper joints from that time may contain lead solder, and drain lines are often cast iron that corrodes from the inside. A plumber can check for corrosion, test water pressure and suggest which sections deserve attention first.
Winter lows in Tulsa reach about 30°F in a typical year, with around 72 nights at or below 32°F. Homes built for milder weather may have water heaters in garages, supply lines in attics and no frost-proof faucets, so an occasional hard freeze can do real damage. A plumber can suggest simple fixes such as foam pipe sleeves and faucet covers.
A mix of gas (58%), electric (40%) and delivered fuels heats homes across Tulsa, so there is no standard water heater setup. Check the tag on your unit for the fuel and capacity, and the serial number, which many manufacturers use to encode age. A local plumber can tell you what a like-for-like replacement would need in your house.
Tulsa County logged 138 flash flood reports from 2015 to 2024, so water intrusion is a realistic concern in Tulsa. Know where your main water shutoff is, keep the water heater and electrical panel above likely flood levels when possible, and ask a plumber about a backflow or backwater valve. After a flood, have supply lines and drains checked before the system is put back in use.
Annual precipitation of about 44.2 in is enough in Tulsa to affect basement moisture, sewer line capacity and root growth in older yards. Plumbing work after wet seasons often includes clearing roots, replacing failing sump pumps and fixing leaks that only show up when the soil is very wet. Ask a local plumber about a camera inspection if backups or slow drains repeat.
Permits, water and local rules in Tulsa
- Plumbing permits: City of Tulsa Development Services
- Water and sewer: City of Tulsa Water & Sewer Department
Trade permits for plumbing work
Tulsa Development Services says that once a building permit is issued, various trade permits such as electrical, mechanical and plumbing may be required, and that active trade permits must be linked to the parent building permit. Only trade contractors who meet City and State requirements and are registered with Development Services may pull trade permits. They can be obtained through the city's Self-Service Portal or from the Trade Permits Center at (918) 596-9656. The page does not address homeowner-pulled permits, so ask the city before starting. Source: City of Tulsa Development Services, permit requirements.
Water hardness depends on which plant serves the address
The City of Tulsa FAQ says average hardness runs 8.2 grains per gallon, or 140 parts per million, for water from the A.B. Jewell plant, which is supplied by Lake Oologah, and 5.2 grains per gallon, or 89 parts per million, for the Mohawk plant, supplied by Lake Eucha and Spavinaw. Which plant serves a home depends on the address, and the city points residents to its water service area map. The FAQ attributes white film on dishes and coffee pots to hardness minerals. Source: City of Tulsa, Frequently Asked Questions About Water.
Lead service line inventory
Tulsa's 2025 water quality report page says the city is inspecting service lines through its True Reads meter program to build a lead service line inventory, with contractors installing meters for about 145,000 residential customers. If a line's material is unknown, the page says it may be lead, and the resident receives an annual notice until the material is identified. For water that has sat in pipes for several hours, the page advises running the tap for 30 to 120 seconds before drinking or cooking. Source: City of Tulsa, 2025 Water Quality Report.
Neighborhoods and districts in Tulsa include Blue Dome, Greenwood, Owen Park, The Pearl, The Heights, Kendall-Whittier, Maple Ridge, Swan Lake, Cherry Street and Brookside.
Common plumbing jobs in Tulsa
Before you hire anyone in Tulsa, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Oklahoma plumbing guide explains where to start.
Common questions in Tulsa
Could my home in Tulsa have polybutylene or other problem pipe?
Homes built from the late 1970s through the mid-1990s sometimes contain polybutylene, a flexible gray or blue plastic supply pipe linked to leaks at its fittings. Copper with lead solder is also possible in homes built before 1986. A local plumber can identify the pipe material at the water heater or main shutoff and explain what to monitor.
Do I need to worry about frozen pipes in Tulsa?
Occasional freezes happen, and homes built for milder weather often have exposed lines. Tulsa sees about 72 freezing nights in a typical year. Before a forecast freeze, cover spigots, disconnect hoses and insulate pipes in attics, garages and exterior walls. Know the location of your main shutoff so you can stop water quickly if a pipe splits.
How hard is the tap water in Tulsa?
The city's FAQ gives average hardness of 8.2 grains per gallon (140 parts per million) for the A.B. Jewell plant and 5.2 grains per gallon (89 parts per million) for the Mohawk plant. Which plant serves a home depends on the address, so check the city's water service area map.
How is Tulsa checking for lead service lines?
The city's 2025 water quality report page says it is inspecting service lines through the True Reads meter program to build a lead service line inventory. A line of unknown material may be lead, and the resident receives an annual notice until the material is identified.