City guide

Plumbers in Richmond, VA

A local guide to plumbing in Richmond, Virginia (Richmond County): numbers on housing, weather and utilities, plus what to check before you hire a plumber.

Population
About 233,655 residents (U.S. Census Bureau 2024 estimate)
County
Richmond County, Virginia
Homes
Median year built 1959; 71% of homes built before 1980, 17% since 2000
Housing mix
44% detached single-family houses; 44% of homes owner-occupied
Home heating fuel
Electricity 60%, utility gas 34%, fuel oil 3%
Winter
Average winter daily low 30°F; about 74 nights a year at or below 32°F
Summer
Average summer daily high 88°F; about 45 days a year at 90°F or hotter
Precipitation
About 47.1 in of precipitation a year; about 8.8 in of snowfall
Flash floods 2015-2024
37 flash flood reports in Richmond County
Electric utility
Virginia Electric & Power Co. serves most local ZIP codes; average residential rate about 13.9 cents per kWh (2023)
ZIP codes
23173, 23219, 23220, 23221, 23222, 23223, 23224, 23225, 23226, 23227, 23234, 23235, 23284, 23298

Plumbing in Richmond: what the local numbers say

With a median build year of 1959 in Richmond, many houses were plumbed before modern materials existed. Older water service lines may be lead or galvanized steel, and your water utility can tell you what material it has recorded for your address. If low pressure, rusty water or slow drains show up, an aging pipe is a common suspect worth having a local plumber inspect.

Occasional freezing nights are enough to cause trouble in Richmond, which sees about 74 of them and roughly 3,740 heating degree days. Because freezes are not constant, many homes lack the protection found in colder regions. Learn where your main shutoff is, insulate exposed pipes and know how to drain outdoor lines. If a pipe does split, shutting off the water quickly limits the damage.

Because electricity is the dominant heating fuel in Richmond (60% of homes), electric water heaters are the norm. Without venting needs, they can go in closets, garages or attics, where a leaking tank can do quiet damage. A drain pan with a drain line, a working shutoff valve and a pressure relief valve are worth asking a local plumber to check.

Flash flooding is an occasional concern around Richmond, with 37 reports in Richmond County between 2015 and 2024. Even a few events can cause sewer backups, sump pump failures and damage to water heaters installed low to the floor. A plumber can check your pump, discharge line and shutoff valves so you are not testing them for the first time during a storm.

About 47.1 in of precipitation falls on Richmond in a typical year. Water from rain-fed sources is often soft, and in some systems soft or acidic water can contribute to pinhole leaks in copper. Wet conditions also encourage root growth and groundwater leaking into old sewer lines. If you see rust-colored water, blue-green stains at fixtures or frequent backups, a local plumber can inspect the lines.

Permits, water and local rules in Richmond

Plumbing and gas permit applications

The City of Richmond's Planning and Development forms page lists a Plumbing Permit Application, described as issued for new installations and remodeling of building plumbing systems, and a Gas Piping Permit Application covering gas piping and gas appliance installation. A plumbing and gas plan requirements document is also linked. The page does not say whether a water heater replacement needs a permit, so a homeowner can ask the Permits and Inspections office at 804-646-4169 before the work starts. Source: City of Richmond, Planning and Development Forms.

Lead service line inventory and replacement

Richmond's lead service line program says the city submitted a map inventorying the material of all public and private water service lines to the Virginia Department of Health by October 2024, and it offers an interactive service line map and a customer survey. The city owns the public part of each line and has replaced it since the early 1980s. Private-side replacement is the property owner's job, with city financial assistance whose first round has reached its funding capacity. Source: City of Richmond, Lead Service Line Program.

Source water and flushing advice

Richmond's water treatment plant sits on the James River, was built in 1924 and can produce up to 132 million gallons per day, according to the Department of Public Utilities. The city posts a yearly water quality report and says lead comes mainly from service lines and home plumbing materials, not from the treatment plant. To reduce exposure, the city advises flushing the tap for 15 to 30 seconds after the water has sat for several hours. Source: City of Richmond, Water Utility.

Neighborhoods and districts in Richmond include Shockoe Bottom, Church Hill, Fulton, Union Hill, Fairmount and Monroe Ward.

Common plumbing jobs in Richmond

Before you hire anyone in Richmond, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Virginia plumbing guide explains where to start.

Common questions in Richmond

Do older homes in Richmond usually need their pipes replaced?

Not always. Homes built before 1960 may still have galvanized steel, cast iron or clay lines, and some have lead service lines. Age alone does not mean replacement; condition does. A plumber can check pressure, inspect drains with a camera and identify pipe material, and your water utility can tell you what it has recorded for the service line.

Do I need to worry about frozen pipes in Richmond?

Occasional freezes happen, and homes built for milder weather often have exposed lines. Richmond sees about 74 freezing nights in a typical year. Before a forecast freeze, cover spigots, disconnect hoses and insulate pipes in attics, garages and exterior walls. Know the location of your main shutoff so you can stop water quickly if a pipe splits.

Who is responsible for a lead service line in Richmond?

Richmond says each service line has two parts. The city owns the public portion and has replaced it since the early 1980s, while the property owner is responsible for the private portion. The city has offered financial assistance for private-side replacement, though the first round of funding has reached capacity.

How can I check what material my Richmond water service line is made of?

The city's Department of Public Utilities provides an interactive service line map and a customer survey as part of its lead service line program. Residents are asked to check the map and complete the survey, because the city says property owner help is critical to its inventory.

Other Virginia cities

Call (844) 609-3677