City guide

Plumbers in Spokane, WA

What plumbing in Spokane, WA depends on: the age of local homes, winter freezes, rainfall and the water utility. Facts below come from official sources. Call to be connected with a local plumber.

Population
About 230,609 residents (U.S. Census Bureau 2024 estimate)
County
Spokane County, Washington
Homes
Median year built 1961; 68% of homes built before 1980, 16% since 2000
Housing mix
64% detached single-family houses; 59% of homes owner-occupied
Home heating fuel
Utility gas 54%, electricity 42%
Winter
Average winter daily low 26°F; about 123 nights a year at or below 32°F
Summer
Average summer daily high 83°F; about 29 days a year at 90°F or hotter
Precipitation
About 17.4 in of precipitation a year; about 45.4 in of snowfall
Flash floods 2015-2024
7 flash flood reports in Spokane County
Electric utility
Modern Electric Water Company serves most local ZIP codes; average residential rate about 6.8 cents per kWh (2023)
ZIP codes
99201, 99202, 99203, 99204, 99205, 99207, 99208, 99217, 99223, 99224, 99258

Plumbing in Spokane: what the local numbers say

Homes in Spokane have a median build year near 1961, which puts many of them in the era of copper supply pipe and cast iron or early plastic drains. Original copper often holds up well, but pinhole leaks, failing shutoff valves and cracked drain lines show up with age. Homes from the late 1970s may also contain polybutylene, a gray plastic supply pipe that a plumber can usually identify on sight.

Winters in Spokane are cold but not extreme, with about 6,020 heating degree days and roughly 123 freezing nights a year. The risk sits in a few places: spigots, laundry and bathroom lines on exterior walls, and pipes in unheated garages or crawl spaces. Frost-proof hose bibs and foam insulation are common fixes, and a plumber can tell you which lines in your house are exposed.

A mix of gas (54%), electric (42%) and delivered fuels heats homes across Spokane, so there is no standard water heater setup. Check the tag on your unit for the fuel and capacity, and the serial number, which many manufacturers use to encode age. A local plumber can tell you what a like-for-like replacement would need in your house.

Spokane gets about 17.4 in of precipitation a year, a semi-arid climate where hard water is common and sudden downpours can overwhelm drains. Scale builds up in water heaters and fixtures, while dry soil and heavy rain cycles may shift buried sewer lines. Ask a plumber about flushing your tank, checking cleanouts and keeping downspouts away from the foundation.

Spokane has a mix of housing: about 64% detached houses alongside apartments, condos and townhomes. Plumbing responsibility depends on the building. In a house, the owner typically handles the water heater and the sewer lateral; in a condo or townhome, some lines may belong to the association. Check your governing documents or ask the property manager before you call a plumber for anything behind a wall.

Permits, water and local rules in Spokane

Separate permits for plumbing work

The City of Spokane's residential permit page says separate permits are required for plumbing, mechanical (heating and air conditioning) and electrical work, in addition to the building permit, and that inspections must be performed after a building permit is issued. It also reminds owners that a Spokane mailing address does not always mean the property is inside city limits, so the county may handle permits instead. The Permit Center can be reached at 509.625.6300. Source: City of Spokane, Residential Services.

Who may pull a permit

Under Spokane Municipal Code 17G.010.070, building permits can be obtained by a contractor with a City of Spokane business license and an active contractor license from the Washington State Department of Labor and Industries, or by the property owner if the owner can claim exemption from state contractor registration. Mechanical permits for gas piping, equipment or appliances go only to contractors with the appropriate license, unless the owner holds a City of Spokane license to install them. Source: Spokane Municipal Code 17G.010.070.

Backflow assemblies tested every year

The City of Spokane says all water services must have an approved backflow prevention assembly installed and tested annually, and that state regulations require residential, multifamily and commercial customers to test their devices every year. Annual testing must be done by a Washington State Backflow Assembly Tester from the list the city links. The Cross Connection Control Program can be reached at 509.625.7969 for questions or to request a water use survey. Source: City of Spokane, Cross-Connection Control and Backflow Prevention.

Aquifer source and galvanized service lines

Spokane's water comes from the Spokane Valley-Rathdrum Prairie Aquifer. The city's water quality page says home lead tests have been in compliance since 1992 and that the EPA required notice by mail to approximately 1,000 property owners whose galvanized service lines may have been connected to lead pipe before 2018, which it calls galvanized requiring replacement. Owners looking to replace service lines may be eligible for the Utility Service Line Repair and Replacement Program. Source: City of Spokane, Our Water Quality.

Neighborhoods and districts in Spokane include Browne's Addition, Hillyard, South Hill, Kendall Yards, Davenport District, West Central, East Central and University District.

Common plumbing jobs in Spokane

Before you hire anyone in Spokane, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Washington plumbing guide explains where to start.

Common questions in Spokane

Could my home in Spokane have polybutylene or other problem pipe?

Homes built from the late 1970s through the mid-1990s sometimes contain polybutylene, a flexible gray or blue plastic supply pipe linked to leaks at its fittings. Copper with lead solder is also possible in homes built before 1986. A local plumber can identify the pipe material at the water heater or main shutoff and explain what to monitor.

Do Spokane homes need a backflow assembly test every year?

The City of Spokane says all water services must have an approved backflow prevention assembly, and that state regulations require every residential, multifamily and commercial customer to test it each year. A Washington State Backflow Assembly Tester must do the test. Call 509.625.7969 for questions.

Where does Spokane's water come from?

The City of Spokane says its water comes from the Spokane Valley-Rathdrum Prairie Aquifer, which it describes as the sole source of water for most people in Spokane County. The city publishes yearly water quality reports and technical water quality information on its water quality page.

Other Washington cities

Call (844) 609-3677