City guide

Plumbers in Arlington, TX

A local guide to plumbing in Arlington, Texas (Tarrant County): numbers on housing, weather and utilities, plus what to check before you hire a plumber.

Population
About 403,672 residents (U.S. Census Bureau 2024 estimate)
County
Tarrant County, Texas
Homes
Median year built 1986; 33% of homes built before 1980, 23% since 2000
Housing mix
60% detached single-family houses; 54% of homes owner-occupied
Home heating fuel
Electricity 71%, utility gas 26%
Winter
Average winter daily low 38°F; about 36 nights a year at or below 32°F
Summer
Average summer daily high 94°F; about 106 days a year at 90°F or hotter
Precipitation
About 36.2 in of precipitation a year
Flash floods 2015-2024
74 flash flood reports in Tarrant County
ZIP codes
76001, 76002, 76005, 76006, 76010, 76011, 76012, 76013, 76014, 76015, 76016, 76017, 76018

Plumbing in Arlington: what the local numbers say

With a median build year around 1986, a typical home in Arlington was plumbed in the 1980s or 1990s. Some homes from that period used polybutylene supply pipe, which was installed until about the mid-1990s and has been linked to leaks at its fittings. Others have copper, early CPVC or PEX. A plumber can usually tell which you have by looking at the pipes near the water heater.

Occasional freezing nights are enough to cause trouble in Arlington, which sees about 36 of them and roughly 2,130 heating degree days. Because freezes are not constant, many homes lack the protection found in colder regions. Learn where your main shutoff is, insulate exposed pipes and know how to drain outdoor lines. If a pipe does split, shutting off the water quickly limits the damage.

In Arlington, where roughly 71% of homes use electric heat, electric water heaters and heat pump water heaters are common choices. Heat pump models need clearance, a condensate drain and enough surrounding air, while standard tanks need a dedicated circuit. Because power and plumbing meet in this appliance, ask which trade will handle each part of an installation.

Tarrant County logged 74 flash flood reports from 2015 to 2024, so water intrusion is a realistic concern in Arlington. Know where your main water shutoff is, keep the water heater and electrical panel above likely flood levels when possible, and ask a plumber about a backflow or backwater valve. After a flood, have supply lines and drains checked before the system is put back in use.

Arlington receives about 36.2 in of precipitation a year, enough to keep drainage, gutters and sewer lines busy through much of the year. Tree roots seek moisture and can enter older clay or cast iron sewer joints, and heavy rain can overload a main line. Slow drains in several fixtures, gurgling or damp spots in the yard are signs to ask a plumber to camera the line.

Permits, water and local rules in Arlington

Permit needed for water heater replacement

A City of Arlington permitting presentation lists water heater replacement or installation, plumbing fixture replacement where applicable, and HVAC replacement among work that requires a permit. It says all city permits must be applied for through the ArlingtonPermits.com portal and that any trade work, including plumbing, must be performed by an individual who holds the license for that trade. When more than one trade is involved, the presentation says a remodel permit is obtained rather than stand-alone permits. Source: City of Arlington, Permitting Process presentation.

Published plumbing permit fees

Arlington's Planning and Development Services fee schedule, effective October 1, 2025, lists a base permit fee of $100.00 for plumbing work not associated with a building permit, plus associated fees. Examples include $20.00 for the first water heater and $7.50 for each additional one, $15.00 for a water line, $30.00 for a lawn irrigation backflow prevention device, and $30.00 for a water softener system. These amounts are as published in 2025 and the schedule can change, so confirm current fees with the city. Source: City of Arlington, Planning and Development Services Fee Schedule.

Common plumbing jobs in Arlington

Before you hire anyone in Arlington, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Texas plumbing guide explains where to start.

Common questions in Arlington

Do I need to worry about frozen pipes in Arlington?

Occasional freezes happen, and homes built for milder weather often have exposed lines. Arlington sees about 36 freezing nights in a typical year. Before a forecast freeze, cover spigots, disconnect hoses and insulate pipes in attics, garages and exterior walls. Know the location of your main shutoff so you can stop water quickly if a pipe splits.

What plumbing helps protect a home from sewer backup during floods in Arlington?

A backwater valve on the sewer line, a sump pump with battery backup and a known main shutoff are common measures. Tarrant County had 74 flash flood reports in 2015 to 2024. Whether a valve suits your home depends on your drain layout and local code, so ask a plumber and check permit rules.

Do I need a permit to replace a water heater in Arlington?

A City of Arlington permitting presentation lists water heater replacement or installation as work that requires a permit, applied for through the ArlingtonPermits.com portal. It also says trade work such as plumbing must be done by an individual who holds the license for that trade. Verify a plumber's license with the state board.

What does the city publish for water heater permit fees in Arlington?

The city's fee schedule effective October 1, 2025 lists a base permit fee of $100.00 for plumbing work not tied to a building permit, plus associated fees such as $20.00 for the first water heater and $7.50 for each additional one. These amounts are as published in 2025 and may change.

Other Texas cities

Call (844) 609-3677