City guide
Plumbers in Irving, TX
What plumbing in Irving, TX depends on: the age of local homes, winter freezes, rainfall and the water utility. Facts below come from official sources. Call to be connected with a local plumber.
- Population
- About 258,060 residents (U.S. Census Bureau 2024 estimate)
- County
- Dallas County, Texas
- Homes
- Median year built 1986; 36% of homes built before 1980, 28% since 2000
- Housing mix
- 39% detached single-family houses; 38% of homes owner-occupied
- Home heating fuel
- Electricity 65%, utility gas 33%
- Winter
- Average winter daily low 38°F; about 29 nights a year at or below 32°F
- Summer
- Average summer daily high 94°F; about 106 days a year at 90°F or hotter
- Precipitation
- About 37 in of precipitation a year; about 1.6 in of snowfall
- Flash floods 2015-2024
- 103 flash flood reports in Dallas County
- ZIP codes
- 75038, 75039, 75060, 75061, 75062, 75063
Plumbing in Irving: what the local numbers say
With a median build year around 1986, a typical home in Irving was plumbed in the 1980s or 1990s. Some homes from that period used polybutylene supply pipe, which was installed until about the mid-1990s and has been linked to leaks at its fittings. Others have copper, early CPVC or PEX. A plumber can usually tell which you have by looking at the pipes near the water heater.
With about 29 freezing nights a year and 2,220 heating degree days, Irving rarely needs cold-weather plumbing measures, which is exactly why a hard freeze can be so damaging. Homes often have pipes in attics, crawl spaces and exterior walls with no insulation. A short checklist helps: cover spigots, protect backflow assemblies and locate the main shutoff before the forecast turns.
In Irving, where roughly 65% of homes use electric heat, electric water heaters and heat pump water heaters are common choices. Heat pump models need clearance, a condensate drain and enough surrounding air, while standard tanks need a dedicated circuit. Because power and plumbing meet in this appliance, ask which trade will handle each part of an installation.
Dallas County logged 103 flash flood reports from 2015 to 2024, so water intrusion is a realistic concern in Irving. Know where your main water shutoff is, keep the water heater and electrical panel above likely flood levels when possible, and ask a plumber about a backflow or backwater valve. After a flood, have supply lines and drains checked before the system is put back in use.
With around 37 in of precipitation in a typical year, Irving homes see steady moisture around foundations. Sump pumps, floor drains and downspout connections matter more than in drier regions. Test a sump pump by pouring water into the pit before a heavy storm, and ask a plumber whether your downspouts or footing drains are tied into the sewer, since local rules on that vary.
Common plumbing jobs in Irving
Before you hire anyone in Irving, ask whether the job needs a permit, get the scope and price in writing, and verify the plumber's license and insurance with the state or local authority. The Texas plumbing guide explains where to start.
Common questions in Irving
What plumbing helps protect a home from sewer backup during floods in Irving?
A backwater valve on the sewer line, a sump pump with battery backup and a known main shutoff are common measures. Dallas County had 103 flash flood reports in 2015 to 2024. Whether a valve suits your home depends on your drain layout and local code, so ask a plumber and check permit rules.
Other Texas cities
- Houston
- San Antonio
- Dallas
- Fort Worth
- Austin
- El Paso
- Arlington
- Corpus Christi
- Plano
- Lubbock
- Laredo
- Garland
- Frisco
- McKinney
- Grand Prairie
- Amarillo
- Brownsville
- Denton
- Killeen
- Mesquite
- Pasadena
- McAllen
- Waco
- Midland
- Lewisville
- Carrollton
- Round Rock
- Abilene
- Pearland
- College Station
- Odessa
- League City
- Richardson
- New Braunfels
- Conroe
- The Woodlands
- Allen
- Beaumont
- Tyler
- Sugar Land
- Edinburg
- Wichita Falls
- Georgetown
- San Angelo